HI-IQ Products Q-1772-RK Instruções de montagem
Procurar online ou descarregar pdf Instruções de montagem para Racks & Stands HI-IQ Products Q-1772-RK. HI-IQ Products Q-1772-RK 3 páginas. Rackmount kit
Imprimir páginaWebsites: www.flatmonitors.com and www.peizen.com
Tool required:
1. No. 2 Phillips screwdriver
2. 3/8" Socket wrench
3. 3/8" Crescent wrench
4. Tie wrap tool
5. Wire cutter, angled tip is recommended
Procedures:
1. It is a good idea to power up and test the monitor before assembling it onto the
rackmount kit, just in case if there is any problem with it (usually very rare).
Otherwise, you may do all the work below and then have to un-do it.
2. If the monitor is working fine, then lay the foam packing material that came in
the box over a flat surface on a table or workbench. The lay the monitor facing
down over the soft foam.
3. Use a No. 2 Phillips screwdriver to remove the monitor from its stand by
removing its four metric screws and washers. Note: Please store the stand and
all the metric screws away in the box the monitor came in. In case of warranty
service, you will need to re-assemble the stand back onto the monitor.
4. Mount the U-bracket onto the monitor with four each 4 mm X 12 mm metric
screws, No. 8 lock washers, and No. 8 flat washers.
PeiZen, Inc.
1227 Flynn Road, Suite 302
Camarillo, CA 93012-6212
Phone: (805) 484-2454, FAX: (805) 383-5909
E-mail:
Assembly Instructions
Q-1772-RK Rackmount Kit
For
1
of 3