Great Land 1P61F Buku Petunjuk dan Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Buku Petunjuk dan Panduan Pengguna untuk Mesin Pemotong Rumput Great Land 1P61F. Great Land 1P61F 19 halaman.

Halaman Cetak
a) Always keep the filtering element
free of grass cuttings and in perfect
working order (see 6.5).
b) If necessary, replace the filtering
element with an original spare part.
Incompatible filtering elements can
impair the efficiency and life of the
engine.
c) Never start the engine without moun-
ting the filtering element properly.
4.5 SPARK PLUG
Not all the spark plugs for endothermic
engines are the same!
a) Use
only
spark
recommended type, with the right
heat range.
b) Check the length of the thread,
because - if too long - it will damage
the engine beyond repair.
c) Make sure that the electrodes are
clean and their gap is correct (see
6.6).

5. STANDARDS OF USE

5.1 BEFORE EVERY USE
Before every use, perform the fol-
lowing checking procedures in order
to assure a regular operation.
5.1.1 CHECK OIL LEVEL
Fig. 2
See the specific chapter (7.1) for the oil
to be used.
a) Place engine level.
IM moteur 139 cc Outsourced texte-GB.indd 7
b) Clean around oil fill.
c) Remove the fillercap (1), clean the tip
d) Remove dipstick again and check
e) If oil is required, add oil of the same
f) Close the fillercap (1) and wipe off
5.1.2 AIR FILTER CHECK
plugs
of
the
The efficiency of the air filter is
fundamental for the engine to work
properly. Do not start the engine if the
filtering element is missing, or broken.
a) Clean the area around the filter cover
b) Remove the cover (1) by releasing
c) Remount the cover (1).
5.1.3 ADDING FUEL
See the specific chapter (7.1) for the
fuel characteristics.
Add fuel only when the engine is cold.
a) Place the lawnmower level.
b) Clean around the fillercap (1).
of the dipstick (2), insert and tighten
down.
the oil level that must be between the
«MIN» and «MAX» marks.
kind up to the «MAX» mark, being
careful not to spill any outside the oil
fill.
any spilled oil.
Fig. 3
(1).
the rear tab (2) and check the
condition of the filtering element (3).
It must be intact, clean and in perfect
working order; if not, either replace it
or carry out maintenance (see 6.5).
Fig. 4
7
GB
11/25/2014 2:35:24 PM