Airconet FC240 Panduan Instalasi - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Termostat Airconet FC240. Airconet FC240 2 halaman. 110-220vac fan coil and hau thermostat installation guide
Halaman Cetak
7. Setup the thermostat:
C →
a)
o
0
F
Temperature mode select:
o
F is Fahrenheit (not compatible with App)
o
C is Celsius (default)
P4 → P2
b)
Select AirCon Type:
P2 is 2 pipes aircon
P4 is 4 pipes aircon (default)
FA → F1 → FC
c)
Fan Logic:
FA - Automatic Fan (fan stop when aircon reaches the set point)
F1 - Fan Always On (no matter what is the set point)
FC - Fan work only in Cool mode (fan stop when aircon reaches set point but not in heat mode)
E1 → E2 → E0
d)
Set point limiting range:
E1 (default)
E2
E0
L1 → L2 → L3 → L4 → L5
e)
AirCon brand IR code selection (optional)
App Setup
New thermostats have red light flashing indicating the thermostat is
not connected to the network. After successful connection to internet
the red light should be normally OFF
Follow the instruction on:
Note: to reset the thermostat network manually, switch off thermostat and
then press and hold the up/down button 10 seconds until all light are off
a) Press
b) Hold + for 3 sec. to enter setup (light will flash)
c)
d) press
e) Follow setup bellow
o
C
o
F
16-32
60-90
18-30
65-85
5-35
40-95
http://www.airconet.net/ap
to Power On thermostat
set 'parameters' with
to change setup mode