Airconet FC240 설치 매뉴얼 - 페이지 2
{카테고리_이름} Airconet FC240에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Airconet FC240 2 페이지. 110-220vac fan coil and hau thermostat installation guide
페이지 인쇄
7. Setup the thermostat:
C →
a)
o
0
F
Temperature mode select:
o
F is Fahrenheit (not compatible with App)
o
C is Celsius (default)
P4 → P2
b)
Select AirCon Type:
P2 is 2 pipes aircon
P4 is 4 pipes aircon (default)
FA → F1 → FC
c)
Fan Logic:
FA - Automatic Fan (fan stop when aircon reaches the set point)
F1 - Fan Always On (no matter what is the set point)
FC - Fan work only in Cool mode (fan stop when aircon reaches set point but not in heat mode)
E1 → E2 → E0
d)
Set point limiting range:
E1 (default)
E2
E0
L1 → L2 → L3 → L4 → L5
e)
AirCon brand IR code selection (optional)
App Setup
New thermostats have red light flashing indicating the thermostat is
not connected to the network. After successful connection to internet
the red light should be normally OFF
Follow the instruction on:
Note: to reset the thermostat network manually, switch off thermostat and
then press and hold the up/down button 10 seconds until all light are off
a) Press
b) Hold + for 3 sec. to enter setup (light will flash)
c)
d) press
e) Follow setup bellow
o
C
o
F
16-32
60-90
18-30
65-85
5-35
40-95
http://www.airconet.net/ap
to Power On thermostat
set 'parameters' with
to change setup mode