Active Thermal Management 3E Petunjuk Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Kipas angin Active Thermal Management 3E. Active Thermal Management 3E 4 halaman.

Connections & Operation
After mounting the fans, select the location for the fan
controller. It has 2 magnets on its flanges, allowing it to
adhere to most audio-video components. Run the fan wires
to the controller, and plug them onto the connectors FAN 1
and FAN 2. Plug the thermal probe's cable onto the
connector THRM on the controller. Plug the power supply
into an AC outlet that is always live, and plug the power
supply's output lead into J1 on the controller. The green
led should light. When the probe's temperature-sensitive
tip reaches approximately 88-90 degrees, the fans will
begin to turn and the red led will light. Use a hair dryer to
test the system; do NOT use an open flame or heat-shrink
gun.
Thermal probe
Fan 1 Fan 2
Choose a permanent location for the thermal probe. It can be located on the component that generates the most
heat when on. It can also be located in the air near the top of the enclosure, if no one component generates a
large amount of heat but together they raise the temperature of the enclosure significantly. Peel the paper
backing off the anchor and press it against the mounting surface for a few seconds.
Note –
When cooling modern home theater systems, the fans may run continuously. Cable boxes, satellite receivers,
some whole-house amplifiers and digital program recorders run continuously. Their heat may be enough to keep
the System 3 fans in operation. The System 3, like all ATM products, is designed to operate continuously,
drawing only a few watts of electrical power while keeping temperatures low in an enclosure.
Active Thermal Management System 3 fan mounting details
25570 Rye Canyon Rd. Suite D
Valencia, CA 91355
661-294-7999 (voice)
661-294-1115 (fax)
techinfo@activethermal.com
www.activethermal.com