Active Thermal Management 3E Istruzioni per l'installazione - Pagina 3

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Ventilatore Active Thermal Management 3E. Active Thermal Management 3E 4.

Connections & Operation

After mounting the fans, select the location for the fan

controller. It has 2 magnets on its flanges, allowing it to

adhere to most audio-video components. Run the fan wires

to the controller, and plug them onto the connectors FAN 1

and FAN 2. Plug the thermal probe's cable onto the

connector THRM on the controller. Plug the power supply

into an AC outlet that is always live, and plug the power

supply's output lead into J1 on the controller. The green

led should light. When the probe's temperature-sensitive

tip reaches approximately 88-90 degrees, the fans will

begin to turn and the red led will light. Use a hair dryer to

test the system; do NOT use an open flame or heat-shrink

gun.

Thermal probe

Fan 1 Fan 2

Choose a permanent location for the thermal probe. It can be located on the component that generates the most

heat when on. It can also be located in the air near the top of the enclosure, if no one component generates a

large amount of heat but together they raise the temperature of the enclosure significantly. Peel the paper

backing off the anchor and press it against the mounting surface for a few seconds.

Note –

When cooling modern home theater systems, the fans may run continuously. Cable boxes, satellite receivers,

some whole-house amplifiers and digital program recorders run continuously. Their heat may be enough to keep

the System 3 fans in operation. The System 3, like all ATM products, is designed to operate continuously,

drawing only a few watts of electrical power while keeping temperatures low in an enclosure.

Active Thermal Management System 3 fan mounting details

25570 Rye Canyon Rd. Suite D

Valencia, CA 91355

661-294-7999 (voice)

661-294-1115 (fax)