Aircraft Automation ECOTRIM Panduan Pilot - Halaman 17
Jelajahi secara online atau unduh pdf Panduan Pilot untuk Sistem Autopilot Aircraft Automation ECOTRIM. Aircraft Automation ECOTRIM 18 halaman. Trim system
Halaman CetakAircraft Automation
5 REVERSING SERVO DIRECTION
5.1
ROLL SERVO DIRECTION
The only setting that can be done in the ECOTRIM is reversing the servo direction.
Find a ½ in plastic plug at the rear of the controller. Remove the plug and you will see
two very small dip switches:
Rotate the knob to trim the airplane to the right, Check the following
If the trim tab is installed on the left-wing aileron: Trim should be moving UP for
-
If the trim tab is installed on the right-wing aileron: Trim should be moving DOWN
-
If the above is inverted, then flick dip switch number 1 as shown in the figure.
Direction can also be inverted by installing a PWM servo signal reverser cable in series
with the servo extension.
17 |
P a g e
ECOTRIM Trim System