ADEMCO LYNX Manual Sistem - Halaman 12

Jelajahi secara online atau unduh pdf Manual Sistem untuk Sistem Keamanan ADEMCO LYNX. ADEMCO LYNX 14 halaman.
Juga untuk ADEMCO LYNX: Panduan Pengguna (17 halaman), Panduan Memulai Cepat (8 halaman)

Halaman Cetak
ADEMCO LYNX Manual Sistem
Ademco Lynx System Manual
feature has been programmed, the system will provide the appropriate voice messages and any system
beeping sounds indicating the status of the security system over the phone lin. (Refer to Summary of
Audible Notification for further information.) The following functions can be performed from any remote
touch-tone telephone:
Disarm the system.
Arm the system in STAY or AWAY mode.
Bypass zones.
Check system status.
The remote access session will be aborted if:
A report must be sent.
Any local or wireless key entry, except [*], is made.
User Code is not entered within eight (8) seconds of call pickup (during the "system.....system
announcement).
No keys are depressed for a period of 15 seconds and while no announcement has been made by
the system. Any remote key entry will, however extend this timeout back to 15 seconds.
It will not be possible to begin a remote access session if:
A report must be sent.
The system is in any Test mode.
During real time clock setting.
Panel is in shutdown mode (programmed by your installer).
Panel is in Macro learning mode.
Remote phone control feature has not been enabled by your installer.
NOTE: If a remote phone session is not granted by the system, for any of the reasons identified
above, a modem tone will be generated before the end of the session.
Using the Remote Phone Control Feature
To use the Remote Phone Control Feature:
1. Dial the control's phone number. If no answering machine is present, the control will pick up
between 1 and 14 rings, depending on the number programmed by your installer and will
periodically announce "SYSTEM ENTER CODE."
2. During a remote phone control session "PC" will be displayed on the control.
3. Enter your [user code]. The system status will be announced.
4. Enter your [user code] once again.
5. Upon entering remote phone control mode the ADT Safewatch QuickConnect Security System will
announce "System, enter code."
http://alpha.adt.com/help/261[11/14/2018 8:02:22 PM]