GREAT PLANES Sport Float Kit ARF Buku Petunjuk - Halaman 12

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mainan GREAT PLANES Sport Float Kit ARF. GREAT PLANES Sport Float Kit ARF 16 halaman.

about 3/8" [9.5mm] from the sides of the floats. Drill 1/16"

[1.6mm] pilot holes for the screws.

2. Mount the floats to the float gear wires, making sure

the right float is on the right side. Note the orientation of the

wires on the floats.

Install the Floats on the Model

1. Install two nylon landing gear straps on the rear

fuselage mounting block using four #4 x 1/2" [12.7mm]

sheet metal screws and four #4 flat washers. Drill 1/16"

[1.6mm] pilot holes for the screws.

2. Place the floats and wires into position on the fuselage.

Secure the rear wire in place with the landing gear straps.

3. Waterproof the ply spacer assembly with some thin CA or

paint. Install the ply spacer assembly in the front gear wire.This

will prevent the forward float wire from moving in the groove.

Secure the wire into place with the landing gear straps.

4. Remove all of the mounting screws from the fuselage and

floats. Harden all of the holes with a couple of drops of thin CA.

After the CA cures, reinstall all of the screws.

If you have not installed an internal servo, proceed to "Install

the Air Rudder Pushrod" on page 13.

1. Plug a "Y" connector into the rudder channel on the

receiver. Plug the rudder servo into one end of the "Y." Route

the other end of the "Y" to the right rear float wire area.

Note: If you have a computer radio system, you could use a

spare receiver channel for the water rudder servo and mix

the air rudder to the water rudder servo. This would allow

independent setup of the throws and trim.

2. Cut a small slot in the fuselage side for the connector.