GREAT PLANES Wright Flyer Buku Petunjuk - Halaman 8

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mainan GREAT PLANES Wright Flyer. GREAT PLANES Wright Flyer 16 halaman. Almost ready to fly electric powered r/c airplane

Halaman Cetak

3. The above photo shows the outer strut on the left

bottom wing where it attaches to the wing at the trailing

edge. Notice the notch in the strut. Locate a short string

and slide one end under the rear edge of the strut and onto

the notch. The other end of the string will be attached in the

next step.

4. Guide the other end of the string through the motor

strut and onto the post at the top of the fuselage upright.

In the same manner, attach the other short string to the right

side of the wing.

5. Using the same technique, install a long string

from the notch at the top of each outer strut to the post at

the bottom of the fuselage uprights on the left and right

sides of the wing.

6. Install the top wing by sliding it into the slots in the top

of the fuselage uprights. Be careful to guide it along the top

of the wing struts. When the top wing is in place, check that

it is centered in the fuselage. The bottom of the wing has the

centerline marked on it.

7. Insert the tops of the wing struts in the proper holes in

the top wing. Once certain the top wing is installed correctly,

use white plastic strut clips to hold the ends of the struts to

the wing. Two clips are required for each strut.

Install the Servos

1. Install the servos in the fuselage frame from the

bottom of the bottom wing using the grommets, brass

eyelets and screws supplied with your servos.

Note: Where the two servos meet, you will be able to use

only one grommet, brass eyelet and screw. A white plastic

cover is included to hold the grommet and servos in place

(as shown in the photo that follows).