Automatic Solutions ASA244BS Panduan Instalasi dan Pemeliharaan - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pemeliharaan untuk Pembuka Gerbang Automatic Solutions ASA244BS. Automatic Solutions ASA244BS 14 halaman. Industrial swing gate operator

Halaman Cetak

2. S

PECIFI CATIONS

41kgs (including arms)

EIGHT

24v 120w

OTOR

100%

UTY CYCLE

8-12 sec/90

PEED

IZE

NOTE:



Specifications based on gate height of approximately 1.8m.



Specifications and in particular the suggested gate sizes can vary depending upon other variables such

as friction of hinges, environmental factors, type of cladding and external influences which may assist

or degrade the recommended gate sizes.

3. I

NSTALLATION

After reading the previous sections in this manual, and having checked for suitable installation, proceed as

follows:-

Electrical Cabling



A suitably rated Isolator and 240v power supply should be available near to where the gate operator

control box is to be mounted.



If electrical cabling needs to be run across the driveway (where the single gate operator is on the

opposite side to the control box) then ensure the appropriate number of cables (see wiring

requirements) are run in conduit and are installed at the correct depths and manner for both the mains

voltage cables and low voltage cables.



Wiring for photo electric cell cabling and safety induction loops etc.

Mechanical Installation



Firstly determine which gate rail the operator arm is to be mounted to.



Run a level from the top of the gate rail across to where the operator is to be installed onto either wall

or post.



Draw a horizontal line on the post or wall which becomes the mounting position of the operator where

the top 2 mounting holes are in line with your level line.

(subject to change without notice)

ETAILS

IRING REQUIREMENTS

240v on Control Box side

2 – 2.5mm

cables to operator for motor

3 – 1.5mm

cables to operator for limits

Control input cables, Output signal cables

NOTE: If the cable run is over 10m long, shielded

cable is to be used for all cables

GATE SIZE

Weight

Open Bar Gate

Clad Gate

Up to 400kg approx.

Up to 4.5m approx.

Up to 4.0m approx