Automatic Solutions ASA244BS Руководство по установке и обслуживанию - Страница 4
Просмотреть онлайн или скачать pdf Руководство по установке и обслуживанию для Открыватель ворот Automatic Solutions ASA244BS. Automatic Solutions ASA244BS 14 страниц. Industrial swing gate operator
Печатать страницу2. S
PECIFI CATIONS
W
:
41kgs (including arms)
EIGHT
M
:
24v 120w
OTOR
D
:
100%
UTY CYCLE
S
:
8-12 sec/90
PEED
S
:
IZE
NOTE:
Specifications based on gate height of approximately 1.8m.
Specifications and in particular the suggested gate sizes can vary depending upon other variables such
as friction of hinges, environmental factors, type of cladding and external influences which may assist
or degrade the recommended gate sizes.
3. I
NSTALLATION
After reading the previous sections in this manual, and having checked for suitable installation, proceed as
follows:-
Electrical Cabling
A suitably rated Isolator and 240v power supply should be available near to where the gate operator
control box is to be mounted.
If electrical cabling needs to be run across the driveway (where the single gate operator is on the
opposite side to the control box) then ensure the appropriate number of cables (see wiring
requirements) are run in conduit and are installed at the correct depths and manner for both the mains
voltage cables and low voltage cables.
Wiring for photo electric cell cabling and safety induction loops etc.
Mechanical Installation
Firstly determine which gate rail the operator arm is to be mounted to.
Run a level from the top of the gate rail across to where the operator is to be installed onto either wall
or post.
Draw a horizontal line on the post or wall which becomes the mounting position of the operator where
the top 2 mounting holes are in line with your level line.
(subject to change without notice)
o
D
ETAILS
W
IRING REQUIREMENTS
240v on Control Box side
2
2 – 2.5mm
cables to operator for motor
2
3 – 1.5mm
cables to operator for limits
Control input cables, Output signal cables
NOTE: If the cable run is over 10m long, shielded
cable is to be used for all cables
:
GATE SIZE
Weight
Open Bar Gate
Clad Gate
:
Up to 400kg approx.
Up to 4.5m approx.
.
Up to 4.0m approx
4