GAI-Tronics Commander CB Instalasi dan Panduan Pengguna - Halaman 13
Jelajahi secara online atau unduh pdf Instalasi dan Panduan Pengguna untuk Telepon GAI-Tronics Commander CB. GAI-Tronics Commander CB 20 halaman. Weather resistant telephones
Halaman Cetak
4. Continue the installation by making the appropriate connections
(section 6).
5. Reconnect the handset / hookswitch. Secure the telephone Front
Casing to the Rear Casing.
5.3.2
Kit No 100-02-0208-001
This accessory is for mounting GAI-Tronics telephones on to the side of
round poles of 100mm to 200mm diameter, or on to square or
rectangular section uprights of 100mm to 150mm across the mounting
surface. For flat mounting on surfaces greater than 150mm across use
the desk or wall mounted methods as appropriate.
NOTE:
Banding straps (large scale worm-drive clamps) are not included in this
kit and must be obtained separately. For details of where banding can
be obtained, refer to GAI-Tronics.
1. Remove rubber feet from the Rear Casing if fitted. Attach the pole
mounting clamp assemblies to the Rear Casing using the M6 x 25
screws provided. Tighten to a torque of 4.5Nm max.
2. Ensuring that the glands are at the bottom, pass a proprietary
banding strap round each of the pole mounting clamps and the
support pole. Tighten securely.
3. Continue the installation by making the appropriate connections
(section 6).
4. Reconnect the handset / hookswitch. Secure the telephone Front
Casing to the Rear Casing.
5. Re-tighten the straps firmly and trim off any excess band material.
For security the driving head of the band may also be sawn off.
Titan CB, Commander CB
Pole mounting
13