Automatic Technology AM-808 Petunjuk Instalasi - Halaman 2
Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Pembuka Pintu Garasi Automatic Technology AM-808. Automatic Technology AM-808 4 halaman.
Halaman Cetak
AM-808 Installation Instructions
Back cover screw
AM-808 Door Openers
ITEM
DESCRIPTION
1
NETWORK TRANSCEIVER NTR-1V1 AY
2
TIMING HARNESS 400MM VR12 AY
4
VELCRO 20 X 50
Preparation of Opener
a. Disconnect the power supply to the opener.
b. Remove the cover or back cover via screw at top.
c. Remove the grommet out of the chassis.
d. Cut (1) one side of the grommet with a knife or scissors.
e. Slide the network timing harness
f. Refit grommet to chassis by sliding the harness through hole before fitting grommet.
g. Connect the harness to the network / programmer pin on the control board.
h. Refit the cover.
Mount and connect Transceiver
a. Plug the other end of the harness into the transceiver
b. Using the velcro
stick the transceiver
4
WARNING: DO NOT drill into the chassis or covers. No screws are
required to secure the transceiver.
Re-setup and Test the Opener
a. Reconnect power and remove the button cover.
b. Setting Limits:
i. If limits have not been set, follow the openers installation sheet to set limits.
ii. If limits were set previously, clear limits and follow openers installation sheet to set
limits.
c. Refer to the Smart Phone Control Kit User Guide to set up network capabilities.
1
2
Network /
Programmer Pin
QTY
1
1
1
into the cut in the grommet.
2
1
on the top of the opener as shown.
1
Grommet
.
1