- ページ 2

ガレージドアオープナー Automatic Technology AM-808のPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。Automatic Technology AM-808 4 ページ。

AM-808 Installation Instructions

Back cover screw

AM-808 Door Openers

ITEM

DESCRIPTION

NETWORK TRANSCEIVER NTR-1V1 AY

TIMING HARNESS 400MM VR12 AY

VELCRO 20 X 50

Preparation of Opener

a. Disconnect the power supply to the opener.

b. Remove the cover or back cover via screw at top.

c. Remove the grommet out of the chassis.

d. Cut (1) one side of the grommet with a knife or scissors.

e. Slide the network timing harness

f. Refit grommet to chassis by sliding the harness through hole before fitting grommet.

g. Connect the harness to the network / programmer pin on the control board.

h. Refit the cover.

Mount and connect Transceiver

a. Plug the other end of the harness into the transceiver

b. Using the velcro

stick the transceiver

WARNING: DO NOT drill into the chassis or covers. No screws are

required to secure the transceiver.

Re-setup and Test the Opener

a. Reconnect power and remove the button cover.

b. Setting Limits:

i. If limits have not been set, follow the openers installation sheet to set limits.

ii. If limits were set previously, clear limits and follow openers installation sheet to set

limits.

c. Refer to the Smart Phone Control Kit User Guide to set up network capabilities.

Network /

Programmer Pin

QTY

into the cut in the grommet.

on the top of the opener as shown.

Grommet