DynaGen ES53 Instalasi dan Panduan Pengguna - Halaman 17

Jelajahi secara online atau unduh pdf Instalasi dan Panduan Pengguna untuk Unit Kontrol DynaGen ES53. DynaGen ES53 18 halaman. Control module

Operation with the control module disabled:

Should the generator be started manually while the control module is disabled from the circuit,

the transfer switch will immediately switch to the generator source. There will be no time delays

prior to this transfer. The automatic transfer switch will be fully operational but with no time

delays with the control module disabled.

Servicing

When servicing the transfer switch, the control module cable should be disconnected at the

transfer switch to prevent starting of the engine while working on the equipment.

What the LED's look like

No LED's ON.

Low Oil, steady

Low Oil, flashing

High Temperature, steady

Over-crank, steady

Over-Speed, steady

Engine Running, steady

Engine Running, flashing

Low Oil steady while

Engine Running Flashing

Installation and User Manual for the ES53 Control Module

LED INDICATIONS

FRONT PANEL LED INDICATIONS

"Ready" unit waiting for start signal,

+12/24 VDC to Auto terminal.

"OFF", no +12/24 VDC to Auto terminal.

Low Oil Pressure Failure

Auxiliary Input Failure

Over-temperature Failure

Engine would not start after specified

Crank tries.

Speed Signal present above Over-Speed

setting

Engine Controller is in running mode of

operation.

Crank-rest period. Cranking will resume

soon.

Oil switch is not closed (miswired or not

Installed). Engine will crank when oil

Condition/Failure

switch verifies.