Automation Correct Coal-trol Digital TS2 V3 Buku Petunjuk - Halaman 3
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Termostat Automation Correct Coal-trol Digital TS2 V3. Automation Correct Coal-trol Digital TS2 V3 16 halaman.
Halaman CetakInstruction Manual
Read and pay careful attention before proceeding!
ATTENTION - Please follow all manufacturers instructions that came
with your stove or furnace. The Coal-Trol Digital is designed to
complement and enhance the safe operation of your appliance.
Specifically, the Coal-Trol Digital control system has been designed
for use with appliances tested to ANSI Standard Designation:
E1509-95, Standard Specification for Room Heaters,Pellet Fuel-
Burning Type and/or UL1482, Room Heaters, Solid Fuel Type.
Use of the Coal-trol Digital™ on appliances not permanently marked with
one of the above designations voids all warranties and may be unsafe.
Contact us or your stove manufacturer if you are not sure that your stove/
furnace is built in compliance with these safety standards.
WARNING - The Coal-trol Digital™ is capable of regulating a coal fire
smaller than required to maintain proper chimney draft. Follow all
manufacturers recommendations for minimum draft pressures and
temperature. The use of mechanical means such as a draft inducer fan
may be required to ensure proper draft at low fire. Installation of a carbon
monoxide detector (not-included) is highly recommended.
Please Keep reading...
THIS PRODUCT HAS A GROUNDING TYPE PLUG AND REQUIRES A
GROUNDING TYPE OUTLET. IF THE PLUG DOES NOT FIT, CONTACT
A QUALIFIED ELECTRICIAN. DO NOT MODIFY THE PLUG IN ANY WAY.
RISK OF ELECTRICAL SHOCK: THE CONTROL MODULE AND
THERMOSTAT HAS NO SERVICEABLE PARTS INSIDE. SEE
WARRANTY FOR SERVICE.
WARNING: BYPASS OF MECHANICAL VENT SPILLAGE SWITCH
(FUME SWITCH) OR BONNET TEMPERATURE LIMIT, IF INSTALLED IS
DANGEROUS. OPERATION MAY CAUSE SEROUS INJURY OR DEATH,
DUE TO CO POISONING OR FIRE.
Automation Correct LLC
Coal-trol Digital™ - Model TS2 V3
Safety Information
Additional Safety Information:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT CONNECT TO A CIRCUIT
AT MORE THAN 150 VOLTS TO GROUND.
FOR INDOOR USE ONLY.
5/2010 R0
Page 3
www.automationcorrect.com