Dynalink A 3605 Panduan Petunjuk Pengoperasian - Halaman 13
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pemanjang Dynalink A 3605. Dynalink A 3605 17 halaman. Hdmi 4k wireless sender system
Halaman CetakA 3605 HDMI 4K Wireless Sender System
Troubleshooting (continued).
Q2. No or bad connection between the HD transmitter and HD
receiver
1. Move the HD transmitter and/or the HD receiver from the immediate
vicinity of the connected HDMI sources and Wi-Fi equipment. These
may affect the range.
2. Slightly adjusting the position of the HD transmitter and/or HD
receiver may already help out.
3. Too much distance or obstacle between HD transmitter and HD
receiver. Try using shorter distances.
4. Disconnect the power adapters from the wall socket and reconnect
them to reboot the 4K wireless HDMI extender.
Q3. I do have picture, but no (or bad) sound
The Wireless HD supports up to 2CH PCM stereo.
Check the audio setting in the settings menu of the connected HDMI
source and manually set it to 2CH PCM stereo when the automatic set-
ting does not work.
Q4. The IR blaster doesn't work
1. Make sure to use the original remote control of the video source.
2. Please stick the IR emitter probe in the surface of IR window of the
source device, if you are not sure the correct position of IR window of
source device,
3. Please refer to the manual of source device.
4. Please point the remote control to the IR receiver probe within 5m.
5. The IR extender cable based on 20KHz-60KHz remote signal protocol,
which support most of the IR remote in the market, for special
standard or old remote may not supported.
12.