Gree 13-04686 Panduan Petunjuk Pengoperasian - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Pendingin Udara Gree 13-04686. Gree 13-04686 20 halaman.
Halaman Cetak
For Slider Casement Air Conditioners
NOTE: These instructions describe installation in a typical wood framed window with a
wood SLIDE-BY sash, or installation in a metal CASEMENT window. Modification may be
necessary when installing in windows made differently than those shown in these
instructions.
A high window accessory kit is available for window heights up to 62" (1575mm).
Part # EA103W.
Meeting Electrical Requirements
AVERTISSEMENT
Electrical Shock and Personal
Injury Hazard
• Electrical ground is required on this
appliance.
• DO NOT ground to a gas line.
• If cold water pipe is interrupted by
plastic, non-metallic gaskets, or other
insulating materials, DO NOT use for
grounding.
• Check with a qualified electrician if you
are in doubt as to whether the appliance
is properly grounded.
• DO NOT modify power supply cord plug.
If it does not fit outlet, have a proper out
let installed by a qualified electrician.
• DO NOT have a fuse in the neutral or
grounding circuit. A fuse in the neutral, or
grounding circuit could result in an
electrical shock.
• DO NOT use an extension cord with this
appliance.
Failure to follow these instructions could
result in electrical shock, serious injury, or
death.
Installation Instructions
TABLE OF CONTENTS
SUBJECT
Electrical Connection ..................................3
Preparing For Installation ..............................4
Installing Unit in a Sliding Window ..............5
Alternate Window Jamb Applications ............8
Installing Unit in a Casement Window ..........9
Important Safety Instructions ........................12-13
Operation of Current Device ........................14
Controls ......................................................14
Air Conditioner Features ..............................16
Care and Cleaning ......................................17
Energy Saving Ideas ....................................17
Avoid Service Checklist ................................18-19
OBSERVE ALL LOCAL GOVERNING CODES AND
ORDINANCES.
DO NOT, UNDER ANY CIRCUMSTANCES,
REMOVE THE POWER SUPPLY CORD
GROUNDING PRONG.
NOTE: If codes permit, and a separate
grounding wire is used; it is recommended
that a qualified electrician determine that the
grounding path is adequate and not interrupt-
ed by plastic, non-metallic gaskets, or other
insulating materials.
RECEPTACLE WIRING
Receptacle wiring should be a minimum of
14 gauge. Use copper wire only. It is your
responsibility to provide proper and adequate
receptacle wiring, installed by a qualified
electrician.
ELECTRICAL REQUIREMENTS
A 115 volt (103.5 minimum, 126.5 maxi-
mum), 60 Hertz, AC only, 15 ampere fused
electrical supply is required. A time delay
fuse or time delay circuit breaker is also
required. A separate circuit, serving only this
appliance, MUST be provided.
2
......1