Automation Dr. Nix QNix 1500 Buku Petunjuk - Halaman 6
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Ukur Automation Dr. Nix QNix 1500. Automation Dr. Nix QNix 1500 12 halaman. Coating thickness gauge
Halaman Cetak
measured value is immediately indicated on the display
accompanied by a "Beep".
The display shows "ERR" (error) if the QNix® 1500 is placed
incorrectly and "INFI" (infinite) if the measurement is out of
range. The same will be displayed, if measurements on non-
metallic
substrates
automatically and shuts off after approx. 10 sec., if it is not
used.
When measuring on rod materials remove the red ring and
align the "V"-groove in the ring of the probe with the rod.
Do not take measurements on magnets. Magnetic fields are
likely to influence the readings with the Fe-probe. Strong
electromagnetic fields may influence all measurements.
Memorizing Measured Values
Optionally, the QNix® 1500 can be delivered with a built-in
memory and an interface RS 232C, offering the following
features:
a) Memory for up to 3900 values
b) Block segmentation up to 999 blocks
Block No. 1
Block No. 2
Block No. 999
c) Display of the calculatory average value in each block
d) Display of the maximum value in each block
e) Display of the minimum value in each block
f) Deleting the last measured value and the entire memory
g) Processing the measured values using interface and
software
Memory Mode (optional)
To work in the Memory Mode, the gauge has to be switched
on (take any measurement). Push both slides on the sides of
the gauge simultaneously and hold them for approx. 1 second.
Let the slides go. The display will show "bloc" alternating with
"b001". The gauge is now in the Memory Mode and all
following
measurements
Measurements in the Memory Mode will be accompanied by
6
are
taken.
Indication b001
Indication b002 as up to
Indication b999
will
be
The
gauge
turns
stored
in
on
Block 1.