Automation Dr. Nix QNix 1500 Buku Petunjuk - Halaman 8
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Ukur Automation Dr. Nix QNix 1500. Automation Dr. Nix QNix 1500 12 halaman. Coating thickness gauge
Halaman Cetak
and let it go. Immediately, you will see the letters "AE" for
"Average" and a number giving you the number of all
measurements in the respective block. This information is
followed by the display of "μm" or "mil" and the value itself,
representing the average or mean value of all measurements
taken in the present block. For example, "AE 22" alternating
with "139 μm" means, that in the active block 22
measurements have been taken and stored and that the
average value is 139 μm.
In order to see the maximum value of the active block, again
push one of the slides forward. The display will show
and
the maximum value. Pushing one of the slides forward again
you will receive the minimum value
of the active block. In
order to leave this mode push one of the slides forward again
or take a measurement.
In case no measurements have been taken in the active block,
it is not possible to get any statistical value. The display will
then read "AE". Then the gauge automatically returns to the
memory mode.
Deleting Measured Values
While operating in the Memory Mode, the QNix® 1500 offers
the possibility to delete the last reading on the display and in
the memory as well as the entire memory. To achieve this,
push one of the slides for longer than 3seconds. The last
reading will be deleted. If the slide is held further on the
display shows "dEL" and "ALL" (alternating) for 3 seconds and
a "Beep" sounds. If the slide is not released within these 3
seconds the entire memory will be deleted.
In case all values in a block are already deleted, the next
deleting process will eliminate the block itself, and the last
measurement in the previous block will be displayed.
The entire memory can also be deleted by use of our
optionally available software.
Processing of Memorized Values
The built-in interface RS 232 allows transfer of the data to a
PC to process the measured data statistically. The respective
plug is mounted on one side of the gauge. A software for
8