Automation Networks Highway Plus ANC-100e Panduan Pengguna - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Adaptor Automation Networks Highway Plus ANC-100e. Automation Networks Highway Plus ANC-100e 19 halaman. Ethernet to data adapter

Halaman Cetak

1. Configuration and Interface

ANC-100e

Ethernet to DH+ Adapter

1. Select the desired settings on the main configuration page

2. Press the "Apply" button

3. The device will reboot automatically and new settings will take effect

IMPORTANT: ANC-100e IP address/mask settings must match the IP settings of your particular

network.

Device Password

IMPORTANT: It is strongly recommended to change the default device password to something else

than the default value to prevent unauthorized access and reconfiguration of the device.

To change the default web interface login password, please follow the steps below:

1. Type in the current password of the device into the "Current Password:" field. The default

password is set to "password" from the factory

2. Type in the desired new password into the "New Password:" field

3. Type in the same new password into the "Confirm Password:" field

4. Click on "Apply" button

5. The device will reboot automatically and the new password will take effect

Firmware Upgrade

IMPORTANT: Only upgrade the firmware with the firmware image provided by Automation

Networks & Solutions LLC. support staff and only when it is necessary to do so.

Make sure that the unit is disconnected from the DH+ network by unplugging the cable from the unit

before proceeding with the firmware upgrade.

1. Open any web browser and enter the ANC-100e IP address in the address bar, default IP

address of the device is set to "192.168.0.230"

2. Enter the username and password and click "OK" button. If you have changed password (see

above), use new one. Default username is set to "admin" and password is set to "password"

User Manual 10