Dynamco CYCLOPS PARALYSER 485 Petunjuk Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Sistem Keamanan Dynamco CYCLOPS PARALYSER 485. Dynamco CYCLOPS PARALYSER 485 13 halaman.

Halaman Cetak

DIAGNOSTICS

For your convenience and peace of mind the P485 features a user friendly diagnostic

facility, that reports the source of the last trigger. The report is produced by disarming

the P485 during or after a siren trigger. The report consists of the normal indicator

disarm flash, followed by 1, 2, 3 or 4 flashes. Each number of flashes denotes a

different trigger source. See the table below for number definitions.

FLASHES

NB: The diagnostic is best viewed through the status LED as the vehicle may also flash

indicators when unlocking. The reporting feature is disabled if the installer has disabled

arm/disarm confirmation indicator flash (see programmable option #9, page 6).

PROBLEM SOLVING

System won't trigger

Ensure that you have allowed at least 40 seconds after arming, before testing.

If testing boot, ensure boot light comes on only when boot switch is operated; it must

not remain on constantly.

Should the problem you are experiencing persist, consult your Cyclops dealer.

The remote control fails to operate

Try your spare remote control as supplied by the vehicle manufacturer.

Contact the dealer from which the vehicle was purchased or vehicle manufacturer

helpline.

TRIGGER SOURCE

Bonnet

Millivolt Sensing

Doors

Glass Breakage

- Page 8 -