Hideaway Concelo CRL160D Petunjuk Instalasi

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Alat Binatu Hideaway Concelo CRL160D. Hideaway Concelo CRL160D 5 halaman.

Halaman Cetak

Concelo Laundry CRL160D

Installation Instructions

Read all instructions before installing this bin unit.

Failure to install the bin correctly may void warranty.

INSTALLATION VIDEO:

NZ: hideawaybins.co.nz/concelo-laundry-installation

AUS: hideawaybins.com.au/concelo-laundry-installation

Or scan the QR code...

New Zealand

Australia

If predrilling using CNC refer to:

NZ: hideawaybins.co.nz/info/downloads

AUS: hideawaybins.com.au/info/downloads

for drilling position CAD files.

HIDEAWAY NEW ZEALAND

09 426 7456 / [email protected] / hideawaybins.co.nz

HIDEAWAY AUSTRALIA

1800 042 642 / [email protected] / hideawaybins.com.au

MEMBERS AND SUPPORTERS OF

Step 1 – Unpack carton

• The hamper and associated parts should be put to one side.

• Inner carton 1 contains collar components to be attached to the door panel.

• Inner carton 2 contains runners and mounting brackets to be mounted to the

cabinet carcase.

Step 2 – Mount collar to door panel

• Open Inner Carton 1 and follow the Concelo CRL160D Laundry Collar Assembly

Instructions within.

Step 3 – Mount runners inside cabinet carcase

• Open Inner Carton 2 and follow the Concelo CRL160D Laundry Runner Installation

Instructions within.

Step 4 – Assemble collar and door panel to runners

• Position collar assembly as shown in Fig 4. TIP: Ensure that runners are pulled

forward, there is a black tab at the front of the runner that can be pulled while

holding the door panel.

FIG.4

• Lower the door panel until a click is heard. TIP: The door panel may need to be

pushed down slightly.

• Close the product and check that it is approximately level. TIP: If the door panel

is significantly out of level it may indicate that it is not clipped down fully on

one side.

Step 5 – Adjust the door panel position

(Fig 5)

• Loosen the 6 door bracket bolts using the 4mm Hex key provided.

• Adjust the door to be square and parallel to carcase and in the correct vertical

position using the adjustment cams.

• Tighten the 6 door bracket bolts.

• Loosen the 6 door mounting screws and adjust the horizontal position of the

door panel.

• Tighten the 6 door mounting screws.

FIG.5

Step 6 – Fit the door bracket covers

(Fig 6)

FIG.6

Step 7 – Install internal tray

and hamper

(Fig 7)

FIG.7