8devices Korlan USB2CAN Panduan Pengguna - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Antarmuka USB 8devices Korlan USB2CAN. 8devices Korlan USB2CAN 17 halaman. High quality isolated usb to can interface
Juga untuk 8devices Korlan USB2CAN: Panduan Pengguna (15 halaman)
Halaman Cetak
2.2 LED indication
Korlan USB2CAN has three LEDs (Power, Error, Info) for device status indication. Device status Indication
modes are listed in the table below.
1 LED (Power)
2 LED (Error)
3 LED (Info)
LED
Only Power LED on
Info LED on, Error LED off
Error LED on, Info LED off
Info and Error LED on
Error and Info LED blinking
2.3 CAN bus termination
A High-speed CAN bus (ISO 11898-2) must be terminated on both ends with 120 Ohms.
Standard termination example.
The 120-Ω characteristic impedance twisted-pair cable must be terminated with an impedance of the same
value to minimized reflected waves that occur from miss-matched impedances. Bad terminal may cause signal
reflections and the transceivers of the connected CAN nodes (CAN- interface, control device) may not work.
The USB2CAN does not have an internal termination. Device must be used on a terminated CAN bus.
USB2CAN
User Guide
There is no driver detected at host device.
CAN interface is not enabled on a host device.
CAN interface enabled, device is ready to receive or send data.
Status description
Device powered on.
CAN send/ receive data.
6