dB Technologies VIO L208 Panduan Pengguna Mulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna Mulai Cepat untuk Pembicara dB Technologies VIO L208. dB Technologies VIO L208 8 halaman.

Thank you for choosing a dBTechnologies Product!

VIO L208 is the new dBTechnologies flagship 2-way professional active line array module. It is equipped with: one

1.4" neodymium compression driver exit (2.5" neodymium voice coil) and two 8" neodymium woofers (2" voice coil).

The full-range acoustical design includes an efficient all-in-one panel with phase corrector, in order to reach the best

coherence in line-array configuration. The mechanical design allows an easy, accurate and quick installation in flown

or stack use. The powerful

controlled by a DSP, which can perform a detailed customization of the output sound of the speaker. In particular,

thanks to the dual rotary encoder interface, it is possible to accurately tune the line-array configuration coverage,

using the FIR filter technology. In addition, the integrated RDNET connections are useful for a remote in-depth line-

array control and configuration.

Check the site

www.dbtechnologies.com

1) Unpacking

The box contains:

N°1 VIO L208

N°1 100-120 V FUSE

This quick start and warranty documentation

2) Easy installation

VIO L208 can be installed in different configurations.

For a quick installation, in each side of the

loudspeakers the user can find:

- Central and rear handles for easy handling (A)

- Two quick-release pin connections for frontal

mounting (B), with upper integrated front arms.

In the rear side the user can find:

- One rear bracket (C) (with movable arm) for line-

array mounting, with splay angles reference holes for

easy setup and two quick-release pins.

VIO L208

www.dbtechnologies.com

DIGIPRO®

G3 amplifier section, capable of handling up to 900 W (RMS power), is

for the complete user manual!

In order to mount the line array, for each module:

- Remove the upper front pins and lift the front arms

in the final position as shown.

- Fasten the arms with the pins in the lower holes.

- Put a second VIO L208 and remove the lower

frontal pins.

- Put this second enclosure on the top of the first.

- Insert the front arms in the position shown, aligning

the related holes.

cod. 420120268Q rev.1.1