dB Technologies VIO L208 Panduan Pengguna Mulai Cepat - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pengguna Mulai Cepat untuk Pembicara dB Technologies VIO L208. dB Technologies VIO L208 8 halaman.
Halaman Cetak
- Fasten the two enclosures using the quick-release
pins of the upper VIO L208.
- Check that all the pins are properly inserted and
locked before other mounting steps.
- Remove the rear pins and put the swing rear
bracket in the final position as shown.
CHECK PERIODICALLY THE INTEGRITY AND THE
FUNCTIONALITY OF THE ENCLOSURE, OF THE
PINS AND OF THE BRACKETS, FOR A SAFE
INSTALLATION. MAKE SURE THAT THE PINS SECURE
PROPERLY THE MODULES AND THAT THEY ARE FULLY
LOCKED.
VIO L208
www.dbtechnologies.com
- If you need a flown installation, only one pin is
required to secure the movable arm. Check that the
arm is inserted in the bracket. Lift the arm (not the
entire VIO-L208 module) to the desired tilt hole. Fasten
one of the two rear pins in the desired angle, and let
the second one in the position "PIN HOLDER". Check
that the pins are fully inserted.
- If you need a
stacked installation,
it is mandatory to
use two pins (of 2
different modules)
to secure the rear
bracket. Check that
the
arm
inserted
bracket. Lift the arm
(not the entire VIO-L
208 module) to the
desired tilt hole and
insert the PIN 1 in to
the related splay angle position. Then lift the VIO-L208
upper module, until you can insert the PIN 2 in the
"ANGLE LOCK" position as shown. Release the upper
enclosure and check that the movable arm leans on the
second pin, fastened in the correct position.
3
-
Insert the movable arm of rear
bracket of the upper enclosure into
the related housing of the lower one.
- Choose the desired splay angle
between the two enclosures.
is
fully
in
the
cod. 420120268Q rev.1.1