Automotive Tazer JL Mini Panduan Pengguna - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Diagnostik Automotive Tazer JL Mini. Automotive Tazer JL Mini 14 halaman. For jeep wrangler jl & gladiator jt 2018-2020
Halaman Cetakdisable or enable factory Halos.
• Set LED Headlights: This setting
is to configure the vehicle for LED
headlights.
• Set LED Fogs: This setting is to
configure the vehicle for LED Fog lights.
• Set LED Tails: Configure the vehicle for
LED taillights. If using aftermarket LED
tails on a factory LED Jeep, switch this
setting to NO then back to YES, this will
clear the bulb out and hyperflash.
• Taillight Type: Reconfigure taillight type
for overseas conversions
Submenu Off-Road:
DRL and other lighting options
• Set Sway Bar: If the Electronic Sway
Bar has been removed, you can use this
setting to delete the warnings. You can
also use this feature to be able to drive
with the sway bar disconnected at any
speed or 4WD range. Simply shift to 4WD,
press the button to disconnect the sway
bar, and once it's disconnected, enter the
Tazer JL Mini JL settings menu and set
the Sway Bar off. It'll remain disconnected
until you set it on again.
• Set EPSteer: This setting is used if you
deleted the factory electronic steering
pump for a hydraulic pump.
• Set LED Front Turn: This setting is
to configure the vehicle for LED front
turn signals. If using aftermarket LED
turns on a factory LED Jeep, switch this
setting to NO then back to YES, this will
clear the bulb out and hyperflash.
• After configuration, perform a few
5 minute sleep cycles. Turn signals
should be run for 20 seconds each
before hyperflash and errors clear up.
• Set Trailer Tow: Configure the vehicle
for MOPAR trailer towing wiring kit
• Set LOCKER: This setting is used if you
deleted the factory axle lockers. You can
delete front only, or both. If the front
locker is deleted then the front axle
disconnect is deleted as well and needs to
be disabled as well.
• Set Front Axle Disconnect: This
setting will delete the factory Front Axle
Disconnect for those that have done axle
swaps. This setting should be used in
conjunction with the Locker setting.
• DTCM: Declare the presence of a Drive
Train Control Module (Rubicon Transfer
Case)
8