Automotive Tazer JL Mini User Manual - Page 8

Browse online or download pdf User Manual for Diagnostic Equipment Automotive Tazer JL Mini. Automotive Tazer JL Mini 14 pages. For jeep wrangler jl & gladiator jt 2018-2020

Print Page

disable or enable factory Halos.

• Set LED Headlights: This setting

is to configure the vehicle for LED

headlights.

• Set LED Fogs: This setting is to

configure the vehicle for LED Fog lights.

• Set LED Tails: Configure the vehicle for

LED taillights. If using aftermarket LED

tails on a factory LED Jeep, switch this

setting to NO then back to YES, this will

clear the bulb out and hyperflash.

• Taillight Type: Reconfigure taillight type

for overseas conversions

Submenu Off-Road:

DRL and other lighting options

• Set Sway Bar: If the Electronic Sway

Bar has been removed, you can use this

setting to delete the warnings. You can

also use this feature to be able to drive

with the sway bar disconnected at any

speed or 4WD range. Simply shift to 4WD,

press the button to disconnect the sway

bar, and once it's disconnected, enter the

Tazer JL Mini JL settings menu and set

the Sway Bar off. It'll remain disconnected

until you set it on again.

• Set EPSteer: This setting is used if you

deleted the factory electronic steering

pump for a hydraulic pump.

• Set LED Front Turn: This setting is

to configure the vehicle for LED front

turn signals. If using aftermarket LED

turns on a factory LED Jeep, switch this

setting to NO then back to YES, this will

clear the bulb out and hyperflash.

• After configuration, perform a few

5 minute sleep cycles. Turn signals

should be run for 20 seconds each

before hyperflash and errors clear up.

• Set Trailer Tow: Configure the vehicle

for MOPAR trailer towing wiring kit

• Set LOCKER: This setting is used if you

deleted the factory axle lockers. You can

delete front only, or both. If the front

locker is deleted then the front axle

disconnect is deleted as well and needs to

be disabled as well.

• Set Front Axle Disconnect: This

setting will delete the factory Front Axle

Disconnect for those that have done axle

swaps. This setting should be used in

conjunction with the Locker setting.

• DTCM: Declare the presence of a Drive

Train Control Module (Rubicon Transfer

Case)