HIFEI Technology Fulcrum Pro 300A Manual - Halaman 5
Jelajahi secara online atau unduh pdf Manual untuk Pengontrol HIFEI Technology Fulcrum Pro 300A. HIFEI Technology Fulcrum Pro 300A 12 halaman. Brushless speed controller
Halaman CetakFulcrum Pro/Pro+ 300A Brushless Speed Controller Manuals
Ш C: ready to run !
—Set ESC's parameters. Do testing on test-bed and select appropriate parameters for the
configuration.
—Check battery's volts
—Use UBEC or separate receiver battery to power the receiver. Switch 'ON', the
green LED on ESC will light for a second and then extinguish. After the two power beeps,
it is time to go.
Note:
When the battery volts discharge and drop down to the set LVC value, the ESC will cutoff output
to motor in the way of set 'Hard' or 'Soft' cutoff type, which notice it's time to change battery pack.
When ESC cutoff output to motor, you can re-start the motor by moving throttle from 0 position
again. But ESC will cutoff again soon in 3 seconds.
Ш D: Wiring anti-spark cables
Fulcrum Pro 300A and Pro+ 300A ESC come with an anti-spark cables.
When run the ESC with 8s and more Lipo cells, please solder the anti-spark cable according to the
below instructions, which would reduce the sparks and prevent ESC from any damage.
www.hifei.com
Page 9
Fulcrum Pro/Pro+ 300A Brushless Speed Controller Manuals
Ⅳ Program the ESCs by Soft on PC
Fulcrum Pro/Pro+ 300A
ESC supports to be fully programmed the parameters by
'Swordfish Program soft' on PC and 'Hifei Program box'.
When program the ESC by soft, a 'USB Linker' is required to link the Swordfish ESC to PC.
'USB Linker' and 'Hifei Program box' are the parts sold separately. Here the instructions will guide
how to program the Swordfish 300A ESC controllers by soft on PC.
Please read the following instructions before programming.
ⅣA: Install Software on PC
A-a: Computer Operation System Requirements
A. Personal computer with Windows XP/ Vista/ Windows 7 operation system.
B. CD-ROM drive (or access to Internet)
C. Available USB port
D. 8 Megabytes hard disk space
E. Computer screen resolution with 800X600, 1024X768(recommended) , 1280X1024
A-b: Hardware
The hardware include Swordfish Pro/ Pro+ 300A ESC, USB Linker (sold separately), a set-up
CD (free to supply).
Swordfish 300A ESC
USB Linker
'Swordfish Program' Software to PC
www.hifei.com
ⅣA: Install
Set-up soft
Page 10