HIFEI Technology KingKongIII Pro Series Petunjuk Manual - Halaman 4

Jelajahi secara online atau unduh pdf Petunjuk Manual untuk Kontrol Jarak Jauh HIFEI Technology KingKongIII Pro Series. HIFEI Technology KingKongIII Pro Series 10 halaman.

Halaman Cetak

There are two Governor Modes in Flight Mode, they are: Exter-

nal Governor and Governor.

External Governor

when you option this one, KingKongIII Pro will act as an ESC

without Governor function, ESC‟s governor function will be

taken over to outside FBL system (such as Vbar/mini Vbar/

Skookum/MB/BeastX). in this case, the start type have to be

set with „soft start‟ and only one of Heli mode parameters can

be option is: Spool Up Rate.(see the following screenshot).

RPM sensor: KingKongIII Pro has a built-in RPM sensor to

provide the rpm signal to the third Flybarless devices such as

Vbar/mini Vbar / Skookum/BeastX Plus, and the RPM signal

specification as following:

RPM Signal Voltage: 3.3v

RPM Signal Duty Cycle : 50%

Internal Resistance: 510 Ohm

Upgrade/RPM

Battery

Please read instructions of Flybarless devices carefully

and understand the specifications before connecting ESC

RPM sensor cable to the devices.

Kingkong III Pro USER MANUALS

RPM Signal

GND

FBL/Receiver

Throttle

www.hifei.com

Governor

The Governor mode acts as an RPM control. Throttle stick posi-

tion determines the RPM that the motor runs and the controller

will attempt to hold that RPM regardless of load changes and

battery voltage decreasing . Thanks to Active Freewheeling ,the

motor RPM control could be available as long as the throttle lev-

el exceed 30%. In Governor Mode, the‟ brake‟ MUST always

disable, „Soft Cutoff‟ and „Soft Start‟ MUST be optioned.

Note: we strong recommend to open the Active Freewheeling

when Governor is option

Spool Up Rate indicates the startup spool up rate, the default

setting is Level 3, higher level numbers

means to approach the head speed faster.

Governor Gain The default setting is grade 9, the higher grade

number means the higher gain.

Head Speed Change Rate The default setting is standard, this

setting indicates the change rate between 2 different head speed

switching (for example, throttle curve switch up from Normal to

Idle1 or Idle1 to Idle2 ,vice versa).

The "Head Speed Change Rate" value also determines the speed

at which the head recovers.

AR Recover Time is Autorotation Recover Time, it also can be

understood as the recover time from Autorotation (TH=0) to

Normal mode. The default setting is „Disable‟, it indicates the

AR is inactived.

10 to 60 Secs can be optioned to determine the recover time that

Autorotation is actived, for example if you program the AR Re-

cover Time to 30 secs, the AR will be available WITHIN 30

secs, in this period the motor can be ramped up to a preset head

speed instead of soft startup, but more than this time ( >30 se-

conds) will lead to the motor engaged with soft startup.

Throttle Calculator is a calculator to help you calculation the

throttle curve according to your desired HS, Gear rate and motor

poles. Please see the following screenshot:

Page 4