Hifionics Samson HS500.4 Panduan Pengguna - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Penguat Mobil Hifionics Samson HS500.4. Hifionics Samson HS500.4 13 halaman. High performance amplifiers
Halaman Cetak
HS1500.1D / HS2500.1D MONO AMPLIFIER APPLICATION
Basic application
Interconnect cable checklist:
Connect the inputs to a suitable source, e.g. a head unit with good quality RCA cables.
Connect the LINE OUT to the inputs of the system highs amplifier.
Use at least #12 gauge speaker wiring. The amps have dual speaker terminals,
simplifying the hookup of multiple speakers. These amps are mono, 1 channel, amplifiers
which have multiple positive and negative connections for ease of wiring. The 2 positives
are the same internally and the 2 negatives are the same internally.
DESIGNATED
MONO OUTPUT
FROM HEAD UNIT
B O O S T
MI N MA X X
HFR-4
PARALLEL MONO
SUBWOOFERS
2-OHMS EACH MINIMUM
HS1500.1D / HS2500.1D
FULL RANGE
STEREO LINE INPUT
Note: You can use the Radio/CD designated mono line output or a full range stereo line output.
For full range stereo line output, you will need an optional "Y-Adaptor" as shown.
Crossover frequency control checklist:
LOW PASS: 40Hz to 150Hz
SUBSONIC:15 Hz to 55 Hz
BASS EQ: 0 to +12dB
Level control checklist:
Refer to the section "Setting up systems after installation for best performance"
Minimum final loudspeaker impedance: 1-Ohm.
Y-ADAPTOR
NOT USED
SUBWOOFER
TO BATTERY +12v
VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND
5