Hifionics Samson HS500.4 사용자 설명서 - 페이지 7

{카테고리_이름} Hifionics Samson HS500.4에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Hifionics Samson HS500.4 13 페이지. High performance amplifiers

Basic application

Interconnect cable checklist:

Connect the inputs to a suitable source, e.g. a head unit with good quality RCA cables.

Connect the LINE OUT to the inputs of the system highs amplifier.

Use at least #12 gauge speaker wiring. The amps have dual speaker terminals,

simplifying the hookup of multiple speakers. These amps are mono, 1 channel, amplifiers

which have multiple positive and negative connections for ease of wiring. The 2 positives

are the same internally and the 2 negatives are the same internally.

DESIGNATED

MONO OUTPUT

FROM HEAD UNIT

B O O S T

MI N MA X X

HFR-4

PARALLEL MONO

SUBWOOFERS

2-OHMS EACH MINIMUM

HS1500.1D / HS2500.1D

STEREO LINE INPUT

Note: You can use the Radio/CD designated mono line output or a full range stereo line output.

For full range stereo line output, you will need an optional "Y-Adaptor" as shown.

Crossover frequency control checklist:

LOW PASS: 40Hz to 150Hz

SUBSONIC:15 Hz to 55 Hz

BASS EQ: 0 to +12dB

Level control checklist:

Refer to the section "Setting up systems after installation for best performance"

Minimum final loudspeaker impedance: 1-Ohm.

Y-ADAPTOR

NOT USED

SUBWOOFER

TO BATTERY +12v

VIA FUSE

REMOTE TURN-ON

CHASSIS GROUND