DBK Drymatic Boost Bar FGPH109 Buku Petunjuk - Halaman 14

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pengering DBK Drymatic Boost Bar FGPH109. DBK Drymatic Boost Bar FGPH109 16 halaman. Adaptable heat drying system
Juga untuk DBK Drymatic Boost Bar FGPH109: Buku Petunjuk (18 halaman)

Halaman Cetak

Troubleshooting:

In the event of a fault the first thing to try is to switch off the machine, remove the plug from the electrical outlet, and then

wait ten seconds. You can then plug it back in and turn it on again, and see if there are any improvements. If not please refer

to this troubleshooting table for causes and solutions.

Fault

No power, red power switch is not

illuminated when in on position.

No display, red power switch

illuminates when in on position.

Unit not producing warm airflow. Fan

symbol is marked with a X

Unit not producing hot air. No

Rotating graphic is shown in hours

display.

Drymatic Wall and Floor System not

inflating

In the event that this list does not cover your particular issue or the solution does not solve the

problem please contact your local Drymatic representative.

Cause

1) Plug fuse blown.

2) Fault with electrical outlet or

power cord.

1) Internal fuse blown.

1) Insufficient airflow

1) Machine has not had sufficient

time to heat up.

2) Temperature setting is lower than

room ambient.

1) Insufficient airflow

Solution

Check plug fuse, if plug type doesn't have a

fuse contact service.

Check electrical output and check cord for

any damage, breaks or cuts. If cord is

damaged seek replacement.

Check Internal fuse, it is located on the

switch panel next to the red power switch.

Replace if necessary.

Try positioning the air mover closer to the

Drymatic Boost Bar or use a higher speed

setting. Check that the air mover meets the

minimum requirements.

The machine will check for stable airflow

before gradually ramping up power. This

can take up to five minutes.

Increase the temperature setting, it may

be that the room is hotter than the

temperature limit set.

Try positioning the air mover closer to the

Drymatic Boost Bar or use a higher speed

setting. Check that the mat is well sealed

around the Drymatic Boost Bar and free to

inflate.

The

minimum

airflow of 650cfm (1100m³/hr) is the

requirement for the Drymatic Boost Bar to

function

correctly.

Inflating

depending on configuration, may require

significantly more airflow.

recommended

mats,