Dynamode 24 ports Giga managed switch Panduan Instalasi Cepat - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Instalasi Cepat untuk Beralih Dynamode 24 ports Giga managed switch. Dynamode 24 ports Giga managed switch 7 halaman. Gigabit management switch
After entering the password, you can access main page of your switch.
3.2 Console Management (Out-of-band)
A local console is a terminal or a workstation running a terminal emulation program
that is connected directly to the switch via the RS-232 console port on the rear of the
switch. Local console management uses the terminal connection to operate the
console program built-in to the Switch a network Administer can manage, control and
monitor the switch from the console program.
To start using the Console Management program, first connect an EIA-232 serial
cable to a COM port on a PC or notebook computer and to the Console Port on the
rear panel of the Switch.
If you are using Microsoft Windows, boot up the computer, go to
"Start"-"Programs"-"Accessories",-"Communications",
and
open
the
"HyperTerminal". After that follow the instructions below to setup a new terminal
connection software, please select the correct COM port and setup the connection
properties according to step 3 below.
1. Type in a name for the connection, select an icon for the connection, and click
"OK".
2. Select the COM port that you are using for this connection and click "OK".
3. Setup the COM port properties by using the information below and click"OK".
NOTE:
The console port is set at the factory for the following configuration:
Baud rate: 115200 bps
Data width: 8 bits
Parity: none
Stop bits:1
Flow Control: None
Dynamode Ltd