909 10CSMS Buku Petunjuk - Halaman 5

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Melihat 909 10CSMS. 909 10CSMS 20 halaman. 15 amp 10" 254mm single bevel laser guided slide miter saw

Halaman Cetak

Safety rules for laser lights

AVERTISSEMENT
CAUTION
RAYONNEMENT LASER – NE PAS REGARDER LE RAYON NI
VISUALISER DIRECTEMENT À L'AIDE D'INSTRUMENTS D'OPTIQUE
LASER RADIATION – DO NOT STARE INTO BEAM
OR VIEW DIRECTLY WITH OPTICAL INSTRUMENTS
Longueur d'onde / Wavelength: 650 nm
Puissance max. / Max Output: 5 mW
Produit laser de classe IIIa / Class IIIa Laser Product
Conforme aux parties 1040.10 et 1040.11
de la norme FDA21 CFR
Complies with FDA21 CFR Parts 1040.10 and 1040.11
VITER L'EXPOSITION – Un rayonnement laser passe par cette ouverture
É
AVOID EXPOSURE – Laser radiation is emitted through this aperture
WARNING.
Do not stare directly at the laser beam.
WARNING.
It may be more difficult to see the laser line in
conditions of bright sunshine and on certain surfaces
A hazard may exist if you deliberately stare into the beam,
please observe all safety rules as follows;
•
The laser shall be used and maintained in accordance
with the manufacturer's instructions.
•
Never aim the beam at any person or an object other
than the workpiece.
•
The laser beam shall not be deliberately aimed at
personnel and shall be prevented from being directed
towards the eye of a person for longer than 0.25s.
•
Always ensure the laser beam is aimed at a sturdy
workpiece without reflective surfaces. i.e. wood or
rough coated surfaces are acceptable. Bright shiny
reflective sheet steel or the like is not suitable for laser
use as the reflective surface could direct the beam back
at the operator.
•
Do not change the laser light assembly with a different
type. Repairs must be carried out by the laser
manufacturer or an authorised agent.
CAUTION.
Use of controls or adjustments or performance
of procedures other than those specified herein may result
in hazardous radiation exposure.
Additional safety rules for miter saws
•
Ensure that the lighting is adequate.
•
Do not use the saw unless the guards are in place.
•
Do not use the saw to cut metal or masonry.
•
Keep the area free of tripping hazards.
•
Do not let anyone under 18 years operate this saw.
•
Always stand to one side when operating the saw.
•
Never use damaged or deformed saw blades. Only use
sharp blades.
•
When cutting round wood, use clamps that prevent the
workpiece from turning on both sides of the blade.
•
Never use your hands to remove sawdust, chips or waste
close by the saw blade.
•
Use only blades as recommended by the manufacturer.
•
Do not use blades manufactured from high speed steel.
•
If the table insert is damaged or worn, have it replaced
by an authorized service center.
•
Before making compound miter cuts, ensure that the
work head is securely fixed in the desired position.
•
Rags, cloths, cord, string and the like should never be
left around the work area.
•
Avoid cutting nails. Inspect the workpiece and remove all
nails and other foreign objects before beginning sawing.
•
Support the work properly.
•
Never reach over the blade to remove waste or off cuts.
•
Do not attempt to free a jammed blade before first
switching off the machine.
•
Do not slow or stop a blade with a piece of wood. Let the
blade come to rest naturally.
•
If you are interrupted when operating the saw, complete
the process and switch off before looking up.
•
Periodically check that all nuts, bolts and other fixings
are properly tightened.
5