Galaxy DX 44V Panduan Pemilik - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Transceiver Galaxy DX 44V. Galaxy DX 44V 9 halaman. Full channel am/fm mobile transceiver

Halaman Cetak

RECEIVER

Sensitivity

Selectivity

Image Rejection

IF Frequency

Adjacent-Channel

Rejection

RF Gain Control

Automatic Gain Control

(AGC)

Squelch

ANL

Noise Blanker

Audio Output Power

Frequency Response

Built-in Speaker

External Speaker (Not

Supplied)

AM: 0.5 µV for 10 dB (S+N)/N at greater than

½ -watt of audio output.

FM: 1.0 µV for 20 dB (S+N)/N at greater than

½-watt of audio output.

AM/FM: 6 dB @ 3 KHz, 50 dB @ 9 KHz.

More than 65 dB.

AM/FM: 10.695 MHz 1

IF, 455 KHz 2

60 dB AM

adjustable

for

optimum

reception.

Less than 10 dB change in audio output for

inputs from 10 to 100,000 microvolts.

Adjustable; threshold less than 0.5 µV.

Switchable

RF type

4 watts into 8 ohms.

300 to 2800 Hz.

8 ohms, round.

8 ohms; disables internal speaker when

connected.

- 3 -

Installation

LOCATION

Plan the location of the transceiver and microphone bracket before starting the

installation. Select a location that is convenient for operation and does not interfere

with the driver or passengers in the vehicles. In automobiles, the transceiver is

usually mounted below the dash panel, with the microphone bracket beside it.

MOUNTING THE RADIO

Your transceiver is supplied with a universal mounting bracket. When

mounting the bracket and radio to your car, make sure it is mechanically strong.

Also provide a good electrical connection to the chassis of the vehicle. Proceed as

signal

follows to mount the transceiver:

1. After you have determined the most convenient location in your vehicle, hold

the transceiver with mounting bracket in the exact location desired. If nothing

will interfere with mounting it in the desired position, remove the mounting

bolts. Before drilling the holes, make sure nothing will interfere with the

installation of the mounting bolts.

2. Connect the antenna cable plug to the standard receptacle on the rear panel.

Most antennas are terminated with a type PL-259 plug and mate with the

receptacle.

3. Connect the red DC power input wire (with the fuse) to +13.8V DC. This wire

extends from the rear panel. In automobile installation, +13.8V DC is usually

obtained from the accessory contact on the ignition switch. This prevents the

set being left on accidentally when the driver leaves the car and also permits

operating the unit without the engine running. Locate the accessory contact on

most ignition switches by tracing the power wire from the AM broadcast

receiver in the car.

4. Connect the black lead to –13.8V DC. This is usually the chassis of the car.

Any convenient location with good electrical contact (remove paint) may be

used.

5. Mount the microphone bracket on the right side of the transceiver or near the

transceiver, using two screws supplied. When mounting in an automobile,

place the bracket under the dash so the microphone is readily accessible.

- 4 -