Galaxy DX 44V Manual do Proprietário - Página 3
Procurar online ou descarregar pdf Manual do Proprietário para Transcetor Galaxy DX 44V. Galaxy DX 44V 9 páginas. Full channel am/fm mobile transceiver
Imprimir página
RECEIVER
Sensitivity
Selectivity
Image Rejection
IF Frequency
Adjacent-Channel
Rejection
RF Gain Control
Automatic Gain Control
(AGC)
Squelch
ANL
Noise Blanker
Audio Output Power
Frequency Response
Built-in Speaker
External Speaker (Not
Supplied)
AM: 0.5 µV for 10 dB (S+N)/N at greater than
½ -watt of audio output.
FM: 1.0 µV for 20 dB (S+N)/N at greater than
½-watt of audio output.
AM/FM: 6 dB @ 3 KHz, 50 dB @ 9 KHz.
More than 65 dB.
st
AM/FM: 10.695 MHz 1
IF, 455 KHz 2
60 dB AM
45
dB
adjustable
for
optimum
reception.
Less than 10 dB change in audio output for
inputs from 10 to 100,000 microvolts.
Adjustable; threshold less than 0.5 µV.
Switchable
RF type
4 watts into 8 ohms.
300 to 2800 Hz.
8 ohms, round.
8 ohms; disables internal speaker when
connected.
- 3 -
Installation
LOCATION
Plan the location of the transceiver and microphone bracket before starting the
installation. Select a location that is convenient for operation and does not interfere
with the driver or passengers in the vehicles. In automobiles, the transceiver is
usually mounted below the dash panel, with the microphone bracket beside it.
MOUNTING THE RADIO
nd
IF
Your transceiver is supplied with a universal mounting bracket. When
mounting the bracket and radio to your car, make sure it is mechanically strong.
Also provide a good electrical connection to the chassis of the vehicle. Proceed as
signal
follows to mount the transceiver:
1. After you have determined the most convenient location in your vehicle, hold
the transceiver with mounting bracket in the exact location desired. If nothing
will interfere with mounting it in the desired position, remove the mounting
bolts. Before drilling the holes, make sure nothing will interfere with the
installation of the mounting bolts.
2. Connect the antenna cable plug to the standard receptacle on the rear panel.
Most antennas are terminated with a type PL-259 plug and mate with the
receptacle.
3. Connect the red DC power input wire (with the fuse) to +13.8V DC. This wire
extends from the rear panel. In automobile installation, +13.8V DC is usually
obtained from the accessory contact on the ignition switch. This prevents the
set being left on accidentally when the driver leaves the car and also permits
operating the unit without the engine running. Locate the accessory contact on
most ignition switches by tracing the power wire from the AM broadcast
receiver in the car.
4. Connect the black lead to –13.8V DC. This is usually the chassis of the car.
Any convenient location with good electrical contact (remove paint) may be
used.
5. Mount the microphone bracket on the right side of the transceiver or near the
transceiver, using two screws supplied. When mounting in an automobile,
place the bracket under the dash so the microphone is readily accessible.
- 4 -