Galaxy DX95T2 Panduan Pemilik - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Transceiver Galaxy DX95T2. Galaxy DX95T2 9 halaman. 10 meter amateur mobile transceiver with built-in frequency counter & starlite face plate

Halaman Cetak

IGNITION NOISE INTERFERENCE

With weak signals, you may experience interference of the signal by background

noise. This radio has NB and ANL circuits which will help reduce background

noise from sources such as your ignition system. However, background electrical

noise may come from several sources and all noise may not be eliminated. With

extremely weak signals, you can operate this radio with the engine turned off,

which should improve reception. If the ign ition noise level is too high to allow

proper operation under most conditions, you should have your installation of the

radio checked by a qualified technician.

ANTENNA

This radio has a jack in the rear for a standard PL-259 antenna plug. If you are

looking for the most range for your transmission, use a vertically polarized,

quarter-wave length antenna. If antenna height is a problem, you may use a shorter,

loaded-type whip antenna although you can expect some loss of transmission range.

To improve performance, your antenna should be matched to your radio. Your

antenna can be adjusted so that it matches your radio.

EXTERNAL SPEAKER

The external speaker jack (EXT SP.) on th e rear panel is used for remote receiver

monitoring. The external speaker should have 8 ohms impedance and be able to

handle at least 4 watts. When the external speaker is plugged in, the internal

speaker is disconnected.

PUBLIC ADDRESS

To use the Public Address (PA) function, first connect an external speaker to the

PA. SP. Jack on the rear of the radio. See the above specifications for a proper

external speaker. Keep th e speaker away from the microphone to avoid acoustic

feedback.