909 DP250LS Buku Petunjuk - Halaman 10
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Bor 909 DP250LS. 909 DP250LS 16 halaman. 1/3 hp 5 speed drill press with laser
Assembly
1. Place base (5) on floor.
2. Place column assembly (6) on base and align the 3 holes
in the column assembly with the holes in the base.
3. Using the 3 bolts secure the column support to the base
and tighten with a 13mm wrench.
4. Fit the table (7) over the column and secure to the
column using the table lock (8).
5. Fit the motor head (12) to the top of the column and
tighten the 2 grub screws using the 4mm hex key.
This will secure the head on the column. The head
should be turned on the column so the output spindle is
approximately aligned centrally over the base.
6. Fit the 3 handle rods to the
handle hub on the drill press
head, attach them by rotating
each handle in a clockwise
direction until tight. Ensure the
rods are tight in the hub.
7. To fit the chuck, ensure the
tapered spindle and the rear
taper in the chuck are clean.
Open the chuck fully so the
jaws are fully retracted. Fit
the chuck on to the tapered
spindle and secure with a
short sharp tap as shown. DO
NOT directly hit the chuck.
Use a piece of timber to
prevent damage to the chuck.
Adjusting the table height
CAUTION.
Always ensure that the drill press is switched
off and the plug is removed from the power point before
making any adjustments.
1. Loosen the table lock (8).
2. Raise or lower the table to the
required height.
3. Align the centre hole in the
table with the centre of the
chuck.
4. Tighten the table lock to
secure the table.
10