909 DP250LS Manual de instruções - Página 10

Procurar online ou descarregar pdf Manual de instruções para Perfurar 909 DP250LS. 909 DP250LS 16 páginas. 1/3 hp 5 speed drill press with laser

Assembly

1. Place base (5) on floor.

2. Place column assembly (6) on base and align the 3 holes

in the column assembly with the holes in the base.

3. Using the 3 bolts secure the column support to the base

and tighten with a 13mm wrench.

4. Fit the table (7) over the column and secure to the

column using the table lock (8).

5. Fit the motor head (12) to the top of the column and

tighten the 2 grub screws using the 4mm hex key.

This will secure the head on the column. The head

should be turned on the column so the output spindle is

approximately aligned centrally over the base.

6. Fit the 3 handle rods to the

handle hub on the drill press

head, attach them by rotating

each handle in a clockwise

direction until tight. Ensure the

rods are tight in the hub.

7. To fit the chuck, ensure the

tapered spindle and the rear

taper in the chuck are clean.

Open the chuck fully so the

jaws are fully retracted. Fit

the chuck on to the tapered

spindle and secure with a

short sharp tap as shown. DO

NOT directly hit the chuck.

Use a piece of timber to

prevent damage to the chuck.

CAUTION.

Always ensure that the drill press is switched

off and the plug is removed from the power point before

making any adjustments.

1. Loosen the table lock (8).

2. Raise or lower the table to the

required height.

3. Align the centre hole in the

table with the centre of the

chuck.

4. Tighten the table lock to

secure the table.