Dynaphos Starter SK-200 Buku Petunjuk - Halaman 6

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Senter Dynaphos Starter SK-200. Dynaphos Starter SK-200 8 halaman. Studio flash

Guide

Sync triggering

Plug the sync cable or connect the flash trigger receiver in the usb port jack

(see p. 2)

Connect

the sunchro cable or the receiver with the camera and set the camera on the max. shutter speed.

(check the camera manual instructions) When pressing the camera shutter release, simultaneously the flash

will fire an impulse.

If you use more than one flash, the others will be activeted through their photo cells. Use the button

turn on or off the photo cell, as well as to set a mode for triggering with 1st or 2nd flash. (the last one is used

when activating through TTL manual flash with Pre Flash function). When the button

indicator flashes

blue, 1st flash trigger mode is set on, when it flashes red the 2nd flash mode is set on. When the photo

cell is turn off, the indicator won't flash. In some cases it is possible the intense of the master flash to be

insufficient to trigger the rest of the flashes through their photo cells. In this case use additional receivers

for each flash.

You can also trigger the flash by the "Test" button 10.

Slave mode

Through the optional FT-16 wireless power control and trigger, you can remotely trigger and control off the

flash power, pilot light and the photo cell of 16 separate flashes (groups) Starter SK. For this purpose you

will need a FT-16 power control and trigger kit

(product № 010288)

The device is specially designed for work

with studio flashes Expert QS, Speedster QT, Craftline GS, Starter DE, Witstro and XEnergizer.

To trigger and power control a flash with FT-16:

- open the battery compartment of the sender and place 2 alkaline batteries 1.5V AA as following the right

polarity.

- mount the sender in the camera HotShoe connector with the control panel towards to you and tighten

the nut