Dynaphos Starter SK-200 Руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Фонарик Dynaphos Starter SK-200. Dynaphos Starter SK-200 8 страниц. Studio flash

5
Guide
Sync triggering
Plug the sync cable or connect the flash trigger receiver in the usb port jack
6
(see p. 2)
Connect
the sunchro cable or the receiver with the camera and set the camera on the max. shutter speed.
(check the camera manual instructions) When pressing the camera shutter release, simultaneously the flash
will fire an impulse.
If you use more than one flash, the others will be activeted through their photo cells. Use the button
4
to
turn on or off the photo cell, as well as to set a mode for triggering with 1st or 2nd flash. (the last one is used
when activating through TTL manual flash with Pre Flash function). When the button
4
indicator flashes
blue, 1st flash trigger mode is set on, when it flashes red the 2nd flash mode is set on. When the photo
cell is turn off, the indicator won't flash. In some cases it is possible the intense of the master flash to be
insufficient to trigger the rest of the flashes through their photo cells. In this case use additional receivers
for each flash.
You can also trigger the flash by the "Test" button 10.
Slave mode
Through the optional FT-16 wireless power control and trigger, you can remotely trigger and control off the
flash power, pilot light and the photo cell of 16 separate flashes (groups) Starter SK. For this purpose you
will need a FT-16 power control and trigger kit
(product № 010288)
The device is specially designed for work
with studio flashes Expert QS, Speedster QT, Craftline GS, Starter DE, Witstro and XEnergizer.
To trigger and power control a flash with FT-16:
- open the battery compartment of the sender and place 2 alkaline batteries 1.5V AA as following the right
polarity.
- mount the sender in the camera HotShoe connector with the control panel towards to you and tighten
the nut
6