iHeater mini 500 IH-101 Panduan Pemilik - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pemanas iHeater mini 500 IH-101. iHeater mini 500 IH-101 8 halaman. Infrared heater

Halaman Cetak

iHeater Mini

quIcK-start GuIde

Thank you for purchasing your iHeater Mini. We hope that you are satisfied with this energy

efficient heating system. To get the best use out of your iHeater, please take the time to read this

guide BEFORE you start to use it. Please note that the Mini is packed with the docking station

attached. To remove the docking station and use as a wall-mount unit, firmly hold onto the back

piece just above the additional outlets, and pull away from the main body of the unit.

quIcK-start GuIde

1. If your iHeater has been shipped or stored in sub-freezing temperatures, please allow the unit to warm to room

temperature before turning on.

2. Plug in your iHeater – either mounted directly into the wall or using the docking station adapter—and press the

ON/OFF switch on top of the unit to the ON position (I). If using the Mini directly in the wall outlet, make sure it is

mounted flush against the wall.

3. Use the temperature UP/DOWN buttons on the front of the heater to set the target room temperature. Note the

temperature displayed indicates the target room temperature you have selected, not the temperature of the room.

4. Press the Fan Speed button on top of the heater, to select low (LL) or high (HH) speed.

5. Press the Timer button on top of the heater, to set the Mini to automatically stay in the stand-by mode for a range

between 1-9 hours (it will still cycle on whenever the room needs heat to reach the target temperature selected).

Each time the button is pressed one hour is added.

WHat tO expect FrOM yOur IHeater

iHeater is NOT intended to replace your furnace,

nor is it intended to be a sole source of heat. Your

iHeater is intended to be a supplemental source of

heat. The goal of the iHeater is to cause your furnace

to cycle less often.

If your furnace is cycling (turning on) every 10 minutes (6

times per hour), the goal of the iHeater is to cause your

furnace to cycle less. If your furnace cycles only 3 times

per hour, then your home heating bill will be reduced.

Note: every home is different, results will vary.

iHeater is not an instant heat source. iHeater will warm

up the elements in your room, wall to wall, ceiling to

floor. This will take some time, based on the size of the

dOn't FOrGet

If you have any questions regarding your iHeater, feel free to contact us. For all Customer Service issues,

please call: 1 (800) 469-0456 or visit us at: www.officialiHeater.com

Thanks again for your purchase. Please continue for detailed instructions and specifications.

to activate your free 3 year warranty, please register your iHeater at www.officialiHeater.com

or complete and mail the enclosed registration card.

room and ceiling height. Once the elements are heated,

a steady heat will remain.

If iHeater is on, it is saving you money! For best results,

iHeater should remain on at all times. With the built-in

thermostat, iHeater will cycle only when necessary.

It is most effective when left on at all times.

iHeater Mini uses approximately 6-7 amps while it is in

the warming process. Once the heating element has

reached its peak, the unit will use 5-6 amps based on

the setting. iHeater works best when mounted directly

into a power outlet on the wall, or the docking station

adapter is plugged directly into a power outlet. It is

not intended to be run through an extension cord.