iHeater mini 500 IH-101 Panduan Pemilik - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pemanas iHeater mini 500 IH-101. iHeater mini 500 IH-101 8 halaman. Infrared heater

Halaman Cetak

iHeater Mini

OperatIOn

1. When mounting the iHeater Mini directly into the

wall without the docking station adapter, press the

unit firmly into the outlet until it is flush against the

wall. Next, ensure air intake and outlets (see page 4)

are clear of obstructions.

2. When not mounting into wall and using the iHeater

Mini docking station adapter, snap the adapter into

the two plugs on back of the unit. Place the unit on

a flat level surface and ensure that the air intake and

air outlet are clear of obstructions.

3. Plug the heater or adapter cord into a

120~60Hz power outlet.

4. Press the ON/OFF SWITCH at the top of the

heater to the ON ( I ) position.

5. Press the fan SPEED button (low or high) to set the

level to suit the area that is going to be heated. Use

the low (LL) setting for small rooms and the high (HH)

setting for larger rooms.

care & cLeanInG

cautIOn! - disconnect power cord before servicing.

1. Ensure that the heater is turned off (the switch on the top of the unit should be in the OFF (O) position.)

Unplug the iHeater Mini from the wall outlet before cleaning.

2. Carefully wipe the exterior of the heater with a soft, damp (not wet) cloth and dry thoroughly with a soft, dry cloth.

3. Over time dust may accumulate on the front vent of the heater. This can be removed by wiping with a damp cloth,

or carefully cleaning using a vacuum cleaner with brush attachment.

4. DO NOT use harsh or abrasive cleaners to clean your heater, as these will damage the surface.

6. Press the temperature UP/DOWN button to set

the target room temperature.

7. Your iHeater will operate continuously until the

programmed temperature is reached. The unit will

then cycle on and off to maintain the desired warmth.

8. If you would like to leave the heater on, in stand-

by mode, in an unoccupied room, you can use the

Timer button , to set the heater to automatically

stay in the stand-by mode for a range between 1-9

hours (it will still cycle on whenever the room needs

heat to reach the target temperature selected).

Each time the button is pressed one hour is added.

9. When you are ready to turn the iHeater off, move

the ON/OFF switch on top of the heater to the

OFF (O) position.

10. Do not remove the heater from the wall outlet

until it has been turned OFF.

11. When using the iHeater Mini additional external

outlets while the unit is turned on, use only items

that require 500 or less watts, like lamps and laptop

computers. Do not use outlets to plug in items that

require more than 500 watts, like vacuum cleaners.