Autool BT160 Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Uji Autool BT160. Autool BT160 10 halaman. Automotive electric system tester

NOTE: DO NOT operate it in area with combustible gas,

dust and explosive conditions. NOT allowed to use it with AC

and over 24V DC circuit.

4.Testing Components Out of Vehicle's

Electrical System

★ Unroll the leads.

★ Connect red clip to positive terminal of vehicle's battery.

★ Connect black clip to negative terminal of vehicle's

battery.

★ Connect auxiliary ground lead to negative terminal of

tested component.

★ Press button to (-) side with LED lighting RED. Contact

the probe tip to positive terminal of tested component to active

the component. If LED turns to GREEN with buzzer sounding,

stop testing and check the component if defective or not, or

rating current of component is higher than that of this tester.

NOTE: DO NOT operate it in area with combustible gas,

dust and explosive conditions. NOT allowed to use it with AC

and over 24V DC circuit.

5.Testing Components in Vehicle's

Electrical System

★ Unroll the leads.

★ Connect red clip to positive terminal of vehicle's battery.

★ Connect black clip to negative terminal of vehicle's

battery.

★ When component's control switch is located at the side

of positive terminal of component , press button to "-" side to

have LED light RED. Contact probe tip to the positive terminal

of component. The component will be activated.