Dynasty EF67B Series Petunjuk Pemasangan & Panduan Pengoperasian Pemilik - Halaman 6

Jelajahi secara online atau unduh pdf Petunjuk Pemasangan & Panduan Pengoperasian Pemilik untuk Perapian Dalam Ruangan Dynasty EF67B Series. Dynasty EF67B Series 8 halaman. Wall mounted electric fireplace

Halaman Cetak
Clean the metal trim using a soft cloth, slightly dampened with citrus oil based product and buff with a clean soft cloth. DO
NOT use brass polish or household cleaners as these products will damage the metal trim. Citrus oil based products can
be obtained at supermarkets or hardware stores.
WARNING: ALWAYS UNPLUG THE CORD BEFORE MOVING OR SERVICING.
DO NOT IMMERSE HEATER IN WATER!
Always turn OFF the heater and disconnect the cord from the electrical outlet before cleaning your heater.
Light accumulated dust may be removed from the heater with a soft cloth or vacuum cleaner.
Wipe the exterior surfaces of the heater occasionally with a slightly damp cloth (not dripping wet) using a solution
of mild detergent and water. Dry the case thoroughly before operating the heater.
Caution: Do not allow water to run into the interior of the heater as this could create a fire or electric shock hazard.
The fan motor is factory lubricated for life and will not require further lubrication.
Store heater in a clean dry place when not in use.
Warning: Any other servicing needed must be performed by an authorized service representative. Do not attempt to
service the unit yourself.
OPERATING INSTRUCTION-CONTROL FUNCTIONS
This appliance can be operated by both remote control and manual button. Once the unit has been properly connected
to an earthed electrical outlet, turn on the main power switch located on the left hand side of the appliance. A beep sho-
uld be heard when the power is first applied.
CAUTION ! The unit's power cord must be connected to a properly grounded and protected 120V outlet.
WARNING! Do not operate the unit if it is damaged or has malfunctioned. If you suspect the unit is damaged,
NOTE! To use both remote and manual function. As the main power switch must be in "ON" position.

CLEANING TRIM

MAIINTENANCE
Always use ground fault protection where required by the electrical code.
please call a qualified service technician to inspect and to replace any part of the electrical system
if necessary.
● Operating by Manual Button
MANUAL ON/OFF SWITCH
This switch turns heater on/off, and permit / prohibits use of remote and
panel push buttons.
FLAME BUTTON
Press the FLAME BUTTON to turn on the Lighting effect, the flame button
can be pressed repeatedly to cycle through the following colour and
intensity settings, HIGH FLAME INTENSITY, MEDIUM FLAME
INTENSITY, LOW FLAME INTENSITY, MEDIUM FLAME INTENSITY +
YELLOW BACKLIGHT, MEDIUM FLAME INTENSITY + BLUE BACK
LIGHT and MEDIUM FLAME INTENSITY + MIXED BACK LIGHT.