Dynasty EF67B Series Petunjuk Pemasangan & Panduan Pengoperasian Pemilik - Halaman 5
Jelajahi secara online atau unduh pdf Petunjuk Pemasangan & Panduan Pengoperasian Pemilik untuk Perapian Dalam Ruangan Dynasty EF67B Series. Dynasty EF67B Series 8 halaman. Wall mounted electric fireplace
Halaman CetakINSTALL YOUR FIREPLACE
Install your fireplace： ： ： ：
Open the box and take out the wall mounting bracket.
Choose a solid and plain wall and then put the bracket on the position where you want to install the fireplace. Mark the 4
holes by a pen from the holes on the bracket. (Fig. 2)
Drill the marked position using a suitable sized drill bit for the chosen fixings.
Take away the bracket and then drill 4pcs Φ8 holes on the wall. Put the plastic wall plug into the hole. (Fig. 3) If the wall is
solid wood, it is no needed to drill the holes on the wood and no needed of the plastic wall plug.
Fix the bracket by 4pcs 5×40 screws (Fig. 4)
Hang the fireplace on the hooks at top and push the fireplace into the bracket and then fix it by 2pcs M5×10 screws. (Fig. 5)
For pebbles version, arrange the white & clear faux stones along the inset window ledge at the front of the firebox.
Install the fireplace front as picture. (Fig. 6) Fix the fireplace front by 2pcs M4×8 screws
Fig. 4
A 15 AMP, 120 Volt, 60 Hz circuit with a properly grounded outlet is required. The unit comes standard with 6 feet (1.8 m)
three wire cord, exiting from the rear of the fireplace. Plan the installation to avoid the use of an extension cord. Preferably,
the fireplace will be on a dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or
the fuse to blow when the heater is in operation.
Fig. 2
ELECTRICAL CONNECTION
1
2
Fig. 5
Fig. 3
1
Fig. 6
2