Dynasty Fireplaces EF43D Petunjuk Pemasangan & Panduan Pengoperasian - Halaman 6
Jelajahi secara online atau unduh pdf Petunjuk Pemasangan & Panduan Pengoperasian untuk Pemanas Listrik Dynasty Fireplaces EF43D. Dynasty Fireplaces EF43D 9 halaman. Electric heater with remote control
Juga untuk Dynasty Fireplaces EF43D: Petunjuk Pemasangan & Panduan Pengoperasian Pemilik Rumah (8 halaman)
Halaman Cetak
Control Panel
Located on the right and top side panel of the fireplace.
BUTTON
POWER SWITCH
HEATER
5
THERMOSTAT
NAME
Turn on the main power supply. A long "beep" sound will be
5
heard when the switch is turned on On Position "I".
Note: The remote control will lost the memory for function
settings when the switch is turned on Off Position "0".
The flame will be cycled Flame A – Flame B – Flame C –
Flame Off.
FLAME
Flame A: full bright flame + little blue
Flame B: full bright flame
Flame C: half bright flame
The heater will be cycled Low – High – Heater Off. You will
see the indicator light illuminates on left to Power Switch.
The indicator light goes out within 10s.
Low: (●○)
High: (●●)
Note:
1. Heater can be used without flame.
2. Whether the heating is working depends on whether the
settled temperature by thermostat is higher than the
environment temperature.
3. The Fan works anterior to the heater about 10s and turns
off later than the heater about 10s.
4. The indicator light in the lower fuel bed always illuminates
when heater is on.
Start with setting 9 and when the room has reached a
desired level, turn the rotary switch counterclockwise until
the thermostat just 'clicks' off. The thermostat will then
maintain the room at the selected level. To increase the
temperature, turn the rotary switch clockwise to a higher
setting.
FUNCTION
6