Gallagher T10 Catatan Instalasi - Halaman 4
Jelajahi secara online atau unduh pdf Catatan Instalasi untuk Pembaca Kartu Gallagher T10. Gallagher T10 12 halaman. Reader
Juga untuk Gallagher T10: Catatan Instalasi (11 halaman), Catatan Instalasi (12 halaman)
Halaman Cetak
1
Introduction
The Gallagher T10 Reader is a smart card proximity reader. It can be installed as either an entry reader
or exit reader. The reader sends information to the Gallagher Controller and acts upon information sent
from the Gallagher Controller. The reader itself does not make any access decisions.
The reader is available in four variants. The card technologies for each variant are shown below.
Reader
T10 Mifare Reader Black
T10 Mifare Reader White
T10 PIV Reader Black
T10 PIV Reader White
The reader can be connected as an HBUS Reader or Cardax IV Reader. An HBUS Reader uses the HBUS
communications protocol to communicate with the Gallagher Controller. A Cardax IV Reader uses the
Cardax IV Reader communications protocol to communicate with the Gallagher Controller.
IMPORTANT: HBUS compatibility
HBUS communications are supported with sites running Gallagher Command Centre vEL7.00 software
(or later).
IMPORTANT: PIV readers
Gallagher PIV readers connect to the Gallagher Controller 6000 High Spec PIV (C305101) only (referred
to as the Controller). Gallagher PIV readers can only be used with sites running Gallagher Command
Centre vEL7.10 software (or later). Gallagher PIV readers are connected as HBUS Readers only.
2
Before you begin
2.1
Shipment contents
Check the shipment contains the following items:
•
1 x Gallagher T10 Reader facia assembly
•
1 x Gallagher T10 Reader bezel
•
1 x M3 Torx Post Security screw
•
2 x 25 mm No.6 self tapping, pan head, Phillips drive fixing screws
•
2 x 40 mm No.6 self tapping, pan head, Phillips drive fixing screws
2.2 Power supply
The Gallagher T10 Reader is designed to operate over a supply voltage range of 9 - 16 Vdc
measured at the reader terminals. The operating current draw is dependant on the supply
voltage at the reader. The power source should be linear or a good quality switched-mode
power supply. The performance of the reader may be affected by a low quality, noisy power
supply.
3E4288 Gallagher T10 Reader | Edition 1 | August 2016
Copyright © Gallagher Group Limited
Product codes
Supported card technologies
C300400
Mifare DESFire EV1, Mifare Plus and
C300401
Mifare Classic
C305400
PIV, PIV-I, Mifare DESFire EV1, Mifare
C305401
Plus and Mifare Classic
Page 4